Search results

From Electriki
Jump to navigationJump to search
  • ...n, and a timer-interrupt ramps from current to new setpoint over the given time.]] ...chai_032_discharge.png|thumb|'''Fig.8: discharging the cap.''' Before each time-measurement, the cap is discharged through a 100 Ohm resistor to (near) gro
    16 KB (2,482 words) - 17:17, 3 May 2010
  • ...r to run until the thermal protection inside the compressor decided it was time to switch off. This happens after the freezer reaches the limit for the coo ...to back-pressure in the pipes. When foodz are loaded into the freezer, the time it takes to warm it all up is much longer and the compressor will not run a
    3 KB (585 words) - 13:52, 11 April 2010
  • Idle = 37 C, 2965 RPM. - from time to time, the CPU fan switch off fully.
    4 KB (637 words) - 22:07, 25 January 2014
  • ...l.com/products/microcontrollers/avr/ Atmel AVR] microcontrollers, and over time, have been using a number of programming-dongles. (By "''programming-d == Time for something new ==
    7 KB (1,093 words) - 12:59, 23 July 2016
  • ...d as changes in light-intensity above a certain magnitude within a certain time. ...a constant voltage (Vcc) charging a cap through an LDR, and measuring the time it takes to charge to a certain voltage. As LDR-resistance decreases with l
    11 KB (1,709 words) - 21:22, 15 December 2012
  • ...ching them to 7V and back to 5V when booting the pc, I decided that it was time for a fan control. ...to have a output resistance of less than 83ohm (math: 5 tau, known wanted time and known C at 6nF)
    6 KB (1,155 words) - 11:32, 9 November 2014
  • This is something i wrote some time in 2k9 just for the hell of it
    3 KB (324 words) - 22:26, 14 July 2011
  • ...e:Michai_017_real_bunnies.jpg|thumb|'''Fig.1: real bunnies.''' Once upon a time (in a galaxy far, far away), Miffy emerged as the next evolutionary step ou [[Image:Michai_017_coke.jpg|thumb|'''Fig.5: Coke.''' When time is a factor and sleep a luxury, Coke is vital.]]
    10 KB (1,630 words) - 11:52, 11 April 2010
  • ...er closing the drawer or by the driver automaticaly (after a pre-set delay time). This is it. No more, no less (or is it?). ...drawer" part. This driver only turns on the light for a pre-set period of time. Yes, the typical *555 monostable operation scheme ('''Figure 1.'''). Excep
    9 KB (1,605 words) - 22:56, 21 November 2011
  • Now is a good time to start/restart blutooth subsystems/daemons so new rfcommo configuration w
    4 KB (607 words) - 21:13, 24 December 2009
  • When ramping a LED's 'on-time' from 0 to 255, it can be seen that the perceived intensity is not linear with the on-time; differences in the low-range (near 0) are
    12 KB (1,967 words) - 00:21, 5 February 2012
  • # take something apart, and take time to figure out how it works ...r increments. The buffer-cap that feeds the cartridge-logic can bridge the time the 2600 is unpowered during each such deliberate powercycle:
    7 KB (1,122 words) - 00:56, 23 March 2016
  • ...auce, this ammount of meat could use 2 beers which did not seems so at the time of cooking.
    2 KB (316 words) - 13:42, 23 August 2011
  • ...fined state. It's just a 480us+ low pulse followed by 480us+ high in which time devices mark their presence. See standard for details, under ''Read Time Slots''.
    5 KB (844 words) - 17:55, 28 February 2011
  • ...e CAN transceiver operational. This allows me to easily keep it ON all the time, by just adding a set of three AA cells and two schottky junctions to it. B ...rm scheduled measurements. This data will be used to draw a temperature VS time graph later on. When starting up the module, it falls into a "do nothing" l
    11 KB (1,952 words) - 22:58, 17 February 2012
  • ...board.''' New one (left) still lacked clamp-diodes and series-resistors at time of pic-taking, mainly because of CBA.]] Workhorse (although it's burning cycles most of the time) is the faithful ATtiny2313 (although the [[:Image:Michai_013_all.jpg|schem
    9 KB (1,379 words) - 11:45, 11 April 2010
  • integrates its input-voltage over time. steps, about 1 V per bit-time (following from the value of ''Vcc'', ''R'' and ''C''
    8 KB (1,219 words) - 13:03, 1 November 2015
  • It was my first ARM related project. Also first time i got in touch with CAN. Never used JTAG before. My C experience was less t ...caly the main module of whole application. It not only diplays the current time and temperature but also the thermostate's set edge value and operation men
    10 KB (1,756 words) - 22:55, 21 November 2011
  • We'll see how this turns out - only time and more PCBs will tell.
    3 KB (427 words) - 17:02, 24 August 2016
  • Rule no. 2: look a 3rd time, yes you have fucked up. Time for a practical example, a Cisco Catalyst 3500 switch, that would not start
    7 KB (1,090 words) - 19:55, 14 January 2012

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)