Difference between revisions of "SPICE3-hacking primer"
Line 1: | Line 1: | ||
− | == | + | __NOEDITSECTION__ |
+ | [[category:support]] | ||
+ | |||
+ | == Why, and what (not) to expect here == | ||
I heard a lot about SPICE, and never used it outside of one of its many fuzzy packages, e.g. PSpice. | I heard a lot about SPICE, and never used it outside of one of its many fuzzy packages, e.g. PSpice. | ||
Line 246: | Line 249: | ||
</pre> | </pre> | ||
|} | |} | ||
+ | |||
+ | ---- | ||
+ | |||
+ | Have fun -- [[User:Michai|Michai]] |
Revision as of 21:49, 7 April 2011
Contents
- 1 Why, and what (not) to expect here
- 2 Real docs
- 3 Examples
- 3.1 Piece-wise linear: voltage-source with V/t-curve consisting of line segments
- 3.2 AC (frequency-) analysis of a simple low-pass filter
- 3.3 Initial conditions: giving a component an initial value
- 3.4 DC-sweep: ramp a (voltage-)source from start- to end-value
- 3.5 Current-measurement using a dummy voltage-source (0V)
- 3.6 Pulsed source using nonzero rise- and fall-times
- 3.7 Physical pushbutton switch using helper voltage-source
- 3.8 Voltage-controlled voltage-source as sad excuse for opamp-model
Why, and what (not) to expect here
I heard a lot about SPICE, and never used it outside of one of its many fuzzy packages, e.g. PSpice. Googling by accident showed that SPICE-models representing simple circuits can be extremely short, so let's try.
- If you spot an obvious mistake, please tell or change this page. - My goal here was clearly to simulate small and isolated parts of circuits using mainly passive components; a simple setup can be hacked together and simulated, well, within tens of seconds, really. - A lot of funny plots are about to greet your eyes. SPICE can do a lot more than all this. - I use the ngspice incarnation on a NetBSD system, plotting directly to my monitor. - No redundant text - learn by example, please, or RTFM (see below).
Real docs
I don't like the original SPICE3 docs; I guess everything is explained, but it feels incoherent and IMHO it could have been twice as long without being too long.
TBD - ori docs in var fgormats - wikipedia - spice models from downstairs pc - spice docs from mail TBD
Examples
Piece-wise linear: voltage-source with V/t-curve consisting of line segments
this text should be below table
AC (frequency-) analysis of a simple low-pass filter
Initial conditions: giving a component an initial value
DC-sweep: ramp a (voltage-)source from start- to end-value
Current-measurement using a dummy voltage-source (0V)
transient analysis: current-measurement using 0V voltage source *** Dummy (0 V) voltage-source 'vsense' between resistor and cap v a 0 dc 1 r a b 1k vsense b c dc 0 c c 0 1u *** Show current through dummy voltage source, and (effectively) cap voltage * * CAVEAT: 'uic' _must_ be added, else cap behaves as open circuit .control tran 10u 10m uic plot i( vsense ) plot b .endc .end |
Pulsed source using nonzero rise- and fall-times
Physical pushbutton switch using helper voltage-source
Voltage-controlled voltage-source as sad excuse for opamp-model
Have fun -- Michai