Difference between revisions of "PCB (etching)"
From Electriki
Jump to navigationJump to search| Line 1: | Line 1: | ||
__NOEDITSECTION__ | __NOEDITSECTION__ | ||
| − | [[category: | + | [[category:support]] |
<gallery widths=200px> | <gallery widths=200px> | ||
Image:IMG 8646 before etching 1.JPG|The etching tank. | Image:IMG 8646 before etching 1.JPG|The etching tank. | ||
Revision as of 11:53, 11 April 2010
The etching tank.
Board treated with photoresistant laquer, UV light and developed later on.
Right after putting the board into etching tank (fresh acid).
Few minutes later... (the acid went a bit blue).
Board right after taking it outta the bath.
Remaining laquer cleared up with acetone.
The complete set of tools i used to etch this one.
Top layer of board... (outta focus but CBA to fix it).
And the bottom layer.
Yeah i have soldered encoder already and screwed the spacers.
